![]() It is not difficult, but it does require you to do some work. This however requires that you learn how to handle several connected adapters on Windows and Linux. (In 'NAT' mode, VirtualBox itself acts like a router and provides DHCP the VM is in a virtual subnet. Since both machines have Samba and the naming daemon running, I would like to access the machines using hostnames, instead of IP address. How it is attached to a real network depends on your VirtualBox settings for each VM. Mac OS X hanxue-Mac.local VirtualBox host Linux Mint mint15 VirtualBox guest The hosts network connection is mostly via Wifi, so both IP addresses are dynamic especially the host. I have created a network: vboxnet1: IPv4 Address: 192.168.57.0 IPv4 Network Mask: 255.255.255.0 IPv6 Address: fe80:0000:0000:0000:0800:27ff:fe00:0000 IPv6 Network Mask Length: 64 Then I have created a virtual machine with 2 interfaces: adapter 1: NAT adapter 2: Host-only. ![]() You need IP address because in order to see machines without a DNS server. So what youre seeing is not your host machines Ethernet its a virtual Ethernet card, often based on Intel e1000 series. I don't know why but I can't ping a virtual machine node from the host. Make sure Network Discovery and File/Print Sharing are ON (or the counterparts for your LINUX OS). ![]() Just in case: you may also have two or more adapters on each VM, so that you can have simultaneously the Bridged adapter (or NAT) that connects you to the world, and the Host-Only adapter that connects to the host and to the other VMs. You have your machine set up as NAT and they are on a separate subnet from the host machine. Start your two VMs Windows will already be connected, for Kali you will need to issue the same two commands as above, i.e.: ifconfig eth0 upĪt this point you will be connected to the Host the host will be 192.168.56.1, and the two VMs 192.168.56.100 and 192.168.56.101 (which is which, between Windows and Kali, depends on which comes up first). There is no need to configure the Advanced Options. Save, then go to your VM panel, choose for the Network adapter Host only. After changes, turn off your guest machines, restart Windows 10 and you should be able to Ping. (C) If you wish to try NAT networking, run the VMware Network Editor and reset the NAT network. Then go to DHCP server, and choose: Enable Server (tick!) If your Windows 10 machine is connected to your router using DHCP (normal), your IP address could have changed. Under Adapter, choose: Ip address 192.168.56.1 Before configuring this in a VM, you must go to the panel File -> Preferences -> Network, select Host only Networks, click on the Plus sign, then the screwdriver. If the host is not connected, you will need Host only network. The above works if the host is connected to a LAN, because both VMs will then get the necessary information (IP address, router's IP address, DNSs) from the LAN router. Network files and commands (ping, ifconfig, netstat, tcpdump, networking config. Choose Bridged Adapter for the connection of all VMs the Windows VM will come up connected, while in Kali, after booting, issue the commands ifconfig eth0 up
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |